Matching models in the JSON is tedious, but working.Model matching does not allow for Premium Aircraft sadly, due to the nature Asobo has encrypted the aircraft.cfg.If this program would use a good feed it would be amazing!įinally a couple of other considerations: Which is why I did pay for the other feed that can be used in that program from RealTraffic. Though it still misses out on some of the GA air traffic. This feed is a lot better for on the ground movement of aircraft. However does anyone know if the author of the program is also reading this forum? Back in the X-Plane days I used a different program for live traffic which uses the free feed from OpenSky Network. I’ve been using this for a few days now and it is indeed very good! As long as the models map to your liveries it works pretty well! For me I’ve turned of the MSFS live traffic and just rely on this for now. This is another issue with ADS-B and not a problem with the program. Headings also seem to not be updated as frequently as position and altitude so aircraft doing higher rate turns might not be pointed the exact right direction. Proper is trying to code around it but it may still be a bit odd for planes on the ground. The real ADS-B data from the aircraft is broadcast every second (give or take) so this is a decision by FlightRadar24 and not ELT’s fault. That is in the data FlightRadar24 is sending. It does not update continually so on the ground aircraft with abruptly move, change heading, etc. FlightRadar24 changes what it reports when planes are on the ground. While getting used to how this all works, I was looking a lot at the FlightRadar24 map view to see what I should be seeing in the sim and it matches amazingly well. In a few moments you should see the list of aircraft start populating with aircraft withing range of your location and should start seeing them in the sim as well. AFTER you spawn into the sim (ELT needs your location), press the connect button in ELT.If you don’t put that path in or do it with typos or other to make it invalid, all you will see are the default Airbus liners. The important thing is to use double backslashes in the settings.json file.) (Note - this appeared incorrectly when I first posted - the message board collapsed double backslashes into single. Mine is a nonstandard location but here is the syntax - he requires double slashes.įor my install, this is my path in quotes: “K:\\FS2020Stuff\\Community\\”. Edit the Settings.json file to point to your community folder.Is there a step by step how to do this anywhere? thanks for your reply. The airplane heading was lagging through the turn but once the pilot went back to flying straight, it caught up. I was flying with a real world 172 that was flying a 360 while sightseeing I guess. ADS-B is a bit slow on heading updates for some reason. It’s just the data itself but the dev is working on smoothing.Īircraft headings and bank angles can be off too. You can see these behaviors in the FlightRadar24 map view. Once airborne, the teleporting stops and you get smooth updates. The position updates are much farther apart in time so the planes jump around a bit on the ground when parked (noise in the reported location) and teleport when taxiing. Last bit is traffic is apparently reported differently once it is determined as being on ground. If all you see are Airbuses, the community folder variable isn’t set or isn’t set correctly. You have to set your community folder location so it can find your aircraft that it can refer to to inject the traffic. You can’t just drop ELT somewhere and run it. You also need to edit the settings.json file to point to your community folder. It only injects traffic you can see from your location so it needs your location first. There is a slight delay so they don’t match completely but they are close - much closer than the FlightAware 5 minute delay with the sim’s built-in real world traffic.įor ELT to inject traffic you have to be spawned in. You can use the FlightRadar map view to see where the planes are. If you open a browser to their map view and look where you are, you should be able to see the aircraft in your area that you should see in the sim. Been sorting this software and it works really well!ĮLT gets its info from FlightRadar24.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |